Jacuzzi BALI, Руководство пользователя

Страница: 39 / 60

39
Q
The end of the scale removal cycle is signalled by the turning off of the LED found
above the button, and the display shows the temperature value of the enclosure area.
Q
YOU can stop the cycle by pressing the button ; wait about five minutes before turn-
ing off the main switch, so that the steam generator is emptied and the solenoid valve is
drained.
Q If two buttons are pressed at the same time by mistake, the control panel may temporarily
lock. Wait for a few seconds for operation to be restored.
Q After use, switch off the shower unit by pressing the "on/off" button .
Then switch off the main switch.
The presence of malfunctions and / or situations that may require the intervention of a
Jacuzzi
® Service Centre are shown on the display for approximately 10 minutes with alpha-
numeric abbreviations (by pressing the button you can delete some messages from the
display; however, the error condition remains).
- First check that the shower unit is powered (main switch on, electric and hydraulic
system functioning, etc.)
- Then follow the indications given for each type of anomaly and try to switch the
shower enclosure off and on again. If the problem persists, contact a Jacuzzi® service
centre.
X
E2 - activation of safety thermostat
- Contact a Jacuzzi® service centre.
X
E3 - the time available for the water load in the steam generator has expired
- Check that the water supply is not closed or faulty;
- Contact a Jacuzzi® service centre.
X
E4 / E5 - temperature probe (or relative circuit) faulty
- Contact a Jacuzzi® service centre.
X E6 - no Bluetooth® device or connection
- Associate a Bluetooth® device or verify that it is connected (refer to the respective chap-
ter);
- Check that the connection has not been interrupted (device too far away, momentary
signal drop, etc.).
X
E7 - failure of the drainage solenoid valve (also see the section on “Special Maintenance”)
- The boiler may need to be inspected; contact a Jacuzzi® service centre.
General notes
Error messages
(only Bali hammam model)