POWER SUPPLY
CABLE WITH GROUND PLUG
The equipment is assembled with a 3-prong ground plug, the round prong
of which is connected to the pump body. So when this plug is connected to the
socket, the pump body will be also connected to the ground wire of the power
supply circuit.
The job of the ground wire is to convey to the ground all electric discharge
in the machine. Therefore, make the installation correctly and never remove the
ground proung (round).
CABLE LENGTH
VOLTAGE
GAUGE (AWG)
SECTION (mm²)
220 V
220 V
127 V
127 V
up to 20 m
from 20 to 50 m
up to 20 m
from 20 to 50 m
1.5
2.5
2.5
4.0
14
12
12
10
TABLE OF WIRE GAUGE
The wiring and extension must be in accordance with the
recommendations below.
ELECTRIC CABLES AND EXTENSION
Use only eletric extension that accepts the connection of cable with
ground plug.
The electrical rating of this extension must not be less than the specified
in this manual.
Always keep the electric extension away from flammable substances,
heat and sharp edges. Always disconnect the electric extension from the power
supply circuit before disconnecting the electricextension from the machine. Do not
use damaged extension.
Should you have any doubt, consult an electrician.
NOTE: Do not try to connect the 3-prong ground plug
to a conventional socket.
POWER SUPPLY
ATTENTION
- KEEP ALL CONNECTIONS DRY.
- DO NOT TOUCH THE PLUGS OR SOCKETS WITH WET HANDS.
- BEFORE CONNECTING THE MACHINE TO THE POWER SUPPLY
CIRCUIT, MAKE SURE THE MOTOR SWITCH IS IN THE POSITION
"OFF". (REFER TO THE FIGURE BELOW)
THESE PRECAUTIONS WILL REDUCE THE RISK OF ELECTRIC
SHOCK.
NOTE:
THESE MACHINES
HAVE A DEVICE
THAT SWITCHES
OFF THE MOTOR
AUTOMATICALLY IN
CASE OF
OVERHEAT.
Off (0)
On (1)
16
17
ATTENTION: THE MACHINE IS NOT SUPPLIED WITH THE ELECTRIC EXTENSION.
Содержание 6500
Страница 2: ......
