9
TRACTOR
CAB
ASSEMBLY INSTRUCTIONS
WWF WINDSHIELD WIPER INSTALLATION
(Except 1000 Series)
1.
Locate mounting position of wiper assembly.
2.
Determine whether adequate space is
available.
3.
Locate approximate stud position on header.
See that blade will wipe the desired area of
windshield.
4.
Should a change of wiping angle be needed:
a.
Remove gear case cover.
b.
Remove spring clip on pivot shaft arm.
c.
Lift link and install in desired degrees on
gear.
d.
Reverse the above procedure to
reassemble.
Wiping angles available are 85, 100, 110, and 120
degrees.
5.
Distance between stud hole and bracket hole
should be 6.25 inches.
6.
Drill tower stud hole first using a 5/8" drill.
7.
Drill mounting bracket hole for a No. 10 screw.
8.
Place the wiper in position and install the
mounting stud attaching nut and washers.
Tighten to 30-50 in. lbs.
9.
Wiring - See diagram. On applications where
mounting is of wood, fiber, glass etc., a separate
ground wire must be attached to the motor and
connected to a battery ground point. A no.14
wire is recommended.
NOTE: Blade and arm should be mounted
approximately 1" minimum away from windshield
molding. Make certain the wiper blade does not
strike at either end of the wiping stroke. If blade
strikes at both ends, it will be necessary to shorten
the arm and blade length or reduce the wiping angle
of the wiper. (Refer to Step 4.)
MAXIMUM ARM AND BLADE RECOMMENDATION
1 - 15" Arm
1 - 15" Blade
Wiring Diagram for WWF Single Speed
Содержание STEINER 75-70710
Страница 14: ...12 TRACTOR CAB CAB PARTS FIGURE 1...
