Jacobsen Greens King IV Plus, Руководство по запасным частям и обслуживанию

Страница: 12 / 102

3 ADJUSTMENTS
en-12
3.5 ANTISWAY SPRING________________________________________________________
1. The antisway spring (C) should be tight but not
under stress.
2. Loosen both nuts on the adjusting rod then adjust the
rear nut as necessary.
3. When properly adjusted, tighten nuts against
bracket.
Figure 3E
3.6 ACCELERATOR PEDAL ____________________________________________________
1. The top of the pedal should not be less than 2-3/4
in. (70 mm) from the floorboard when pedal is fully
depressed.
2. Loosen locknut (D) and adjust carriage bolt (E) to
obtain the correct distance between pedal and
floorboard.
Figure 3F
3.7 BRAKE PEDAL ___________________________________________________________
1. Drive straight forward with traction lever in MOW
position and throttle in SLOW position. Depress
Brake pedal. If the brake pedal comes too close to
the floorboard, check the amount of brake lining left.
a. Replace lining.
b. Adjust nut (F) to obtain a distance of 3-5/16 in.
(84 mm), between rod pivot points, (when brakes
are new), and to compress spring to 31/32 in. (24
mm).
2. If machine pulls right, turn adjusting nut (F) on left
side clockwise. If machine pulls left, turn adjusting
nut (F) on left side counterclockwise. Do not
compress either spring past 7/8 in. (22 mm).
Figure 3G
C
GKV-2
2-3/4 in. (70 mm)
Fully Depressed
E
D
GKV-3
3-5/16 in.
(84 mm)
F
GKV-4
31/32 in.
(24 mm)