Jacobsen ECLIPSE 360, Руководство по безопасности, эксплуатации и техническому обслуживанию

Страница: 49 / 148

B
OPERATION
en-49 Safety, Operation, & Maintenance Manual
Lithium
TO DRIVE / TRANSPORT______________________________________________
Read and follow all safety notes contained in this manual when driving or transporting mower.
See Operating Proce -
dures on page 46 for general operating instructions. When operating in reverse, look behind you to ensure you have a
clear path.
Important: If this mower is driven on public roads, it must comply with federal, state, and local ordinances.
Contact local authorities for regulations and equipment requirements.
1. Disengage mow switch. Reels will automatically raise to the transport position once mower starts moving.
2. Depress traction pedal slowly.
3. Move the parking brake switch to the OFF position. The parking brake should disengage and mower will start mov
-
ing.
CENTER REEL DELAY _______________________________________________
The raising and lowering of the center reel is slightly delayed from the front reels. When mowing, this allows the center
reel to contact the ground at the same location as the front reels, resulting in an accurate cut.
The length of delay is automatically adjusted for any change in vehicle speed, which is determined by the speed sensor
in the drive motor. If the unit is not in motion or if there is no speed sensor signal, the center reel delay will default to a
time of approximately 2 seconds. There is no delay when lift system is in service mode (Mow switch is OFF).
OVERLOAD PROTECTION ____________________________________________
The reel drive motors and lift actuators are controlled by the RCU. The RCU has built–in overload protection and will dis -
able the motor or actuator if it is drawing too much electrical current.
If there is an overload on a reel drive motor, the circuit breaker will trip, the motor will be disabled, the reel will raise to the
up position and the fault light on the LDU will flash two times per second.
If there is an overload on a lift actuator, the actuator will be disabled and the fault light on the LDU will flash two times per
second.
To reset an overload fault condition, the mower must be shut down and re-started. If the problem persists, inspect the
device and the electrical system to determine the cause of the overload or contact an authorized Jacobsen dealer.
MOWING ___________________________________________________________
CAUTION
To prevent tipping or loss of control, travel at
reduced speed when making turns.
WARNING
To prevent serious injuries, keep hands, feet, and
clothing away from reel when the blades are moving.
NEVER use your hands to clean reels. Use a brush
to remove grass clippings from blades. Blades can
be sharp and could cause injuries.
To clear obstructions from reel, turn mow switch
OFF, stop the mower, turn system power switch to
OFF, and remove key, then remove obstruction.
!
!