Jacobsen Eclipse 322 62800, Техническое руководство по ремонту

Страница: 70 / 82

3-34 4271491-Second Edition
GENSET AND BATTERY PACK
3
18. Lift and disengage strap (12) from fuel tank bracket
(14) and secure out of the way.
19. Remove fuel tank (11) from machine.
20. Tag and disconnect fuel hose (2) from bottom of fuel
tank.
Installation Notes
• Install fuel tank by reversing the order of removal.
• Use only clean gasoline of the correct type (unleaded
gasoline with minimum 85 octane rating) from a
clean, sealed container.
• If fuel was contaminated, install a new fuel filter at
this time. (See “Fuel Filter (Gasoline Models)” on
page 3-34.)
Fuel Filter (Gasoline Models)
Removal and Installation
See Figure 3-54.
1. Park the mower safely. (See “Park Mower Safely” on
page 1-6.)
2. Allow the engine to cool completely.
3. Raise the hood.
Figure 3-54
4. Loosen hose clamps (3 and 5).
5. Tag and disconnect fuel tank-to-fuel filter hose (1)
from the fuel filter (2). Cap fitting and plug hose to
prevent leakage and contamination.
6. Tag and disconnect fuel filter-to-fuel pump hose (4)
from the fuel filter (5). Cap fitting and plug hose to
prevent leakage and contamination.
Installation Notes
• Install fuel filter by reversing the order of removal.
• Make sure the flow arrow on the side of the fuel filter
is aligned with the fuel tank-to-fuel pump flow
direction.
Genset (Gasoline Models)
Removal and Installation
See Figures 3-55 through 3-63.

WARNING
1. Park the mower safely. (See “Park Mower Safely” on
page 1-6.)
2. Allow the engine to cool completely before
attempting to service the engine.
3. Swing center cutting unit from beneath the machine.
4. Raise the hood.
5. Remove cowlings. (See “Cowlings” on page 7-33.)
6. Remove starter battery. (See “Starter Battery” on
page 3-43.)
7. Remove starter battery tray. (See “Battery Charger”
on page 3-44.)
8. Remove muffler and exhaust assembly. (See “Muffler
(Gasoline Models)” on page 3-31.)
9. Remove throttle actuator. (See “Throttle Actuator
(Gasoline Models)” on page 3-32.)
10. Remove GCU. (See “GCU” on page 4-155.)
11. Remove fuel tank. (See “Fuel Tank (Gasoline
Models)” on page 3-33.)
12. Disconnect choke cable from engine.
NOTE
Label all wires before disconnecting to ensure correct
installation.
13. Tag and disconnect the wiring harness at the voltage
regulator, ignition modules, fuel shutoff solenoid,
starter motor, and starter solenoid.
TN2796
5
1
2
3
4
Be sure that the key switch is off, all electrical
accessories are turned off, and the 12-volt and
48-volt power connectors are disconnected
before starting work on vehicle.