Jacobsen AR3, Руководство по безопасности, эксплуатации и техническому обслуживанию

Страница: 44 / 76

en-44
JACOBSEN AR3
SAFETY, OPERATORS & MAINTENANCE MANUAL
9 ADJUSTMENTS
9.5 BLADE SHARPENING
Blades may be sharpened by filing or grinding. When
sharpening, maintain blade balance within 19.4 g/cm
(5/8 oz/in). Failure to keep the blade balanced causes
excess vibration, blade wear and shortened blade
life, and may harm other mechanical components of
the machine as well.
To check blade balance
1. Determine if there is a lighter end.
2. Attach a 3.9g (1/8 oz) weight to the lighter
end 127mm (5in) from the centre of the
blade.
3. If the blade is adequately balanced, the
weight should convert the light end into the
heaviest end. If correction is required, file
or grind the heavy end to obtain balance.
9.4 BLADE CHANGE
1. Remove blade bolt (A).
2. Remove blade (B) from deck .
3. Fit new blade.
3. Replace blade assembly to hydraulic motor
spindle.
4. Tighten blade bolt with torque wrench (C)
set to 95N-m (70 ft-lb) torque.
CAUTION
Blades are extremely sharp and can cause
severe cuts. For your protection, hold blade
with thick leather work glove only.
NOTES:
• Do not overheat or weaken blades when
sharpening.
• Do not straighten bent blades.
* If the lift portion of the blade is worn thin,
replace with a new blade.
• Replace cracked or bent blades.
• For greatest safety always use genuine
replacement blades .