6
POWER
BLOWER
ASSEMBLY
ASSEMBLY INSTRUCTIONS
1. Remove parts from shipping crate.
2. Remove complete belt shield assembly (Ref. 22 & 24, Figure 1) from main frame.
3. Place the hitch frame inside the main blower housing channel aligning the six bolt holes to the frame.
(See Figure 1)
4. Fasten securely with six (6) 3/8 X 3/4 flange bolts.
5. Reinstall belt shield (Ref. 22 ) to the main frame.
6. Place correct drive belt on blower drive pulley. (Refer to Attachment Belt Size Chart). Replace the belt
shield (Ref 24).
7. Remove the shaft, bolt and nut for the anti—scalp roller from the skid plate. Insert the shaft into the
roller and reinstall in the lower hole on the skid plate.
8. Refer to Figure 2 and attach the discharge chute to the blower housing as shown.
9. Check all bolts and pulleys. Tighten as needed. Rotate the blower rotor and check for free rotation.
NOTE:
This is a high speed balanced rotor and care must be taken to have clearance within the housing to
avoid damage to rotor or premature failure of parts. If any interference is found contact your Jacobsen
dealer.
10. Attach the blower to the power unit (tractor). Engage the PTO slowly and gradually increase engine
speed to full throttle to obtain maximum blower speed.
Содержание 73-70642
Страница 9: ...7 POWER BLOWER PARTS SECTION PARTS SECTION ...
Страница 10: ...8 POWER BLOWER POWER BLOWER PARTS FIGURE 1 ...
Страница 12: ...10 POWER BLOWER DISCHARGE CHUTE FIGURE 2 ...
