Jacobsen 69158, Руководство по эксплуатации

Страница: 11 / 20

CONTROLS 4
11
Figure 4A
Engine
Oil
Engine Charge
Pressure
Return
Filter
Hydraulic
Oil
Charge
Filter
Air
Filter
Glow
Plug
Temperature
Coolant
Light
Light Light Temperature
Light
Light Light Light Light
Right
Turn
Signal
Left
Turn
Signal
Alert Action
1.
Engine Oil Pressure
- Alarm sounds
and oil pressure light comes on. Oil
pressure low.
Stop tractor immediately, lower implements and shut off engine!
Inspect oil
level in engine. If oil light remains on with oil at proper level, shut off engine and
tow or trailer tractor back to service area.
NEVER
operate engine with oil light on,
severe damage to the engine can occur.
2.
Engine Coolant Temperature
Horn sounds. Engine coolant
temperature high.
Stop tractor immediately, lower implements and shut off engine!
Remove
debris such as leaves and grass clippings that may be restricting air flow through
rear screen on hood and area between radiator and oil cooler. If engine continues
to run hot, return tractor to service area.
CAUTION
: Engine coolant is under pressure. Turn engine off and allow
fluid to cool before checking fluid level or adding coolant to radiator.
3.
Charge Pressure
Light stays on
after starting engine or comes on
during operation. Indicates low
charge pressure in traction system.
Stop tractor immediately, lower implements and shut off engine!
Check
hydraulic oil level in main tank. Visually inspect tractor for obvious signs of leaks
around connections, hoses and tubes. Tow or trailer tractor back to service area.
Never
operate tractor with charge pressure light on, severe damage to hydraulic
system components can result.
CAUTION
: Hydraulic system is under pressure. Turn engine off and allow
oil to cool before checking oil level or adding oil to tank.
4.
Hydraulic Return Oil Filter
- Oil
filter warning light comes on.
Return tractor to a service area as soon as possible
. Change hydraulic return
oil filter.
5.
Hydraulic Oil Temperature
Horn
sounds. Hydraulic oil temperature
high.
Stop tractor, disengage drives and lower implements.
Run engine at low idle
for a few minutes until light goes off. If light remains on, shut off engine and allow
hydraulic system to cool. Remove debris such as leaves and grass clippings that
may be restricting air flow through rear screen on hood and area between
radiator and oil cooler. If engine continues to run hot, return tractor to service
area.
CAUTION
: Hydraulic system is under pressure. Turn engine off and allow
oil to cool before checking oil level or adding oil to tank.
6.
Hydraulic Charge Oil Filter
- Oil
filter warning light comes on.
Return tractor to a service area as soon as possible
. Change hydraulic
charge oil filter.
7.
Air Filter
- Air filter warning light
comes on.
Return tractor to a service area as soon as possible
. Change air filter.
!
!
!