MAINTENANCE AND LUBRICATION 8
en-65
How To Bleed The Air From The Fuel System
After the fuel filters are replaced or the fuel hoses are disconnected, bleed the air from the fuel system.
a
Open the air vent at the top of the filter.
b
Turn the ignition switch to the RUN position, but do not start the engine. Operate the fuel pump until air
bubbles at filter vent stop and fuel starts to spill. Close the air vent. Clean any fuel that spills.
c
Start the engine. The engine will remove any air remaining in the fuel hoses.
8.10 AIR CLEANER ____________________________________________________________
Check the service indicator (1) each day. If the red band becomes visible
in the window (2), replace the filter element.
Only remove the filter element when replacement is required. Removal of
the filter that is not necessary increases the risk of dust and other
particles to enter the engine.
When service is needed, first clean the outside of the filter housing (4),
then remove the filter element carefully.
Clean the inside of the filter housing. Make sure dust and other particles
do not get into the engine inlet hose.
Inspect the new element. Do not use a damaged element and never use an incorrect element.
Install the filter element. Make sure the element seats correctly. Press the button (3) to set the service indicator.
Install the cap (5) onto the filter housing (4). Make sure the cap seals around the filter housing. The dust valve (6) on
the cap must be at the bottom of the filter. Fasten the cap with the two clips.
Check the air filter hose for wear or damage. Make sure the hose clamps are tight and hold the hose in position.
CAUTION
The diesel fuel can damage your skin. Use gloves when you use diesel fuel. If diesel fuel touches your
skin, clean the area immediately.
CAUTION
Discard diesel fuel in accordance with local safety regulations
!
!
1
2
3
4
5
6
Содержание 672256G01
Страница 96: ......
Страница 97: ...SPECIFICATIONS 12 en 95...