Jacobsen 63286G01, Техническое руководство

Страница: 21 / 56

OPERATION 6
21
6.5 TRANSPORT WHEELS (OPTIONAL KIT 62293) _________________________________
1. Push and hold the kickstand against the ground then
pull the mower handle back until the mower rests on
the stand
(L) .
2. To remove wheels, press retaining clip (J) away
from the hub and pull wheel off hub.
3. To install wheels, set brake, press retaining clip (J) ,
place wheel on hub, and turn the wheel backwards
until studs on back of wheel line up with holes in
hub
(K) . Push wheel in and release clip.
4. Always disengage reel clutch lever (E) , prior to
transporting the mower more than a few feet.
5. Push the mower forward off the kickstand, start the
engine, and engage the O.P.C. bail
(C) .
6. When using a vehicle to transport the mower, apply
parking brake, stop engine, and close fuel shut-off
valve. Chock or block the wheels.
7. Keep tires inflated to 6 to 8 psi (0.41 to 0.55 BAR).
Figure 6D
6.6 GRASS CATCHER _________________________________________________________
1. When the basket is about two thirds (2/3) full of grass
clippings, move mower off the green.
2. Stop on a flat surface, disengage all drives, and
stop the engine.
3. Remove and empty the grass catcher. Use a long
handle brush to remove grass clippings from the
mower.
WARNING
Always stop the engine and disengage the drive
levers before installing or removing the transport
wheels.
!
J
K
L
DANGER
To prevent serious injury, always stop the engine,
and disengage all drives before emptying grass
catcher.
!