14
Battery Power System Set-up:
The JACO Battery System is shipped in “cut-off” mode to prevent power drain during shipping. Follow the steps
below to activate the power system and calibrate the status LED readout properly.
1.
Integrate your PC or Laptop
– After your Mobile Cart is unpacked and ready to go, you should take
the time to properly install the computer system (details on page 7 above)
It is critical that as you integrate a PC or Laptop into the JACO 500 Series Cart with Battery Power that
you do not block the air vents on the battery inverter/charger assembly that resides within the Cart top
assembly. The PC or Laptop must sit on the divider plate as shown below on the right. Rout all cables
neatly and use the ty-wraps and Velcro pads provided in the Cart Accessory kit.
Top Assembly with Inverter/Charger Assembly Top Assembly with Integrated PC
2.
Wake-up the Battery System
– Plug the recharge power cord that is hanging from the back of the
Mobile Cart into any standard 120VAC wall outlet to “Activate” the Battery Power System.
3.
Unplug the power cord
– This step is needed as you need to let the battery system drain completely
so that the status LED readout will be properly calibrated.
4.
Turn on power to the AC Outlets
– Push the AC Switch shown as item 2 on page 12, to the ON
position to provide power to the AC outlets. This switch can be accessed from the left side of the Cart
Top Assembly as shown below.
