0,5 Bar
Min.
Max.
Pressure Flow Rates
Dynamic Pressure
Recommendations for Proper Use
Installation Instructions
Self Closing Valve
Maintenance
Water Temperature
3 Bar
1 Bar
Max.
2 Bar
8 L/m
0,5 Bar
60°C / 140° F
18 L/m
11 L/m
5 Bar
15 L/m
jaclo
industries
| 129 Dermody Street Cranford, NJ 07016
p
908.653.4433 | 800.852.3906
f
908.653.1717 | 800.852.4133
REVISED 7.01.15
JACLO.COM
| PG 2
To prevent impurities or debris from getting inside the product and causing functional problems, always flush out
the system before connecting it to the supply pipes.
It is recommended to install the filter at the system’s water
intake.
To keep the diffuser clean and prevent lime scales from clogging the diffuser, we advise that you periodically rub
the silicone nozzles to free them of the lime deposits.
IMPORTANT!! TO ENSURE THE CORRECT INSTALLATION OF THE SHOWER COLUMN IT IS NECESSARY TO
DECIDE IN ADVANCE WITH PLANNERS / INSTALLERS THE DESIRED DIRECTION OF THE SHOWERHEAD. THE
FINAL POSITION OF THE SHOWER COLUMN IS DETERMINED BY THE FIXATION OF THE BASE (3) TO THE
FLOOR AS SHOWN IN FIGURE A. ARRANGE WATER SUPPLY AT THE DESIRED LOCATION ACCORDINGLY.
1. Mark the four base (3) fixation points on the floor, checking the correct positioning of the shower direction as
per Figure A according to the determined shower direction.
2. Drill 4 holes with a 14mm bid then insert anchors (8)
3. Mount the straight pipe (2) with the base (3) and secure with M6 screws (6) with on/off valve (13) positioned in
the same direction as foreseen for showerhead.
4. Secure the straight pipe and base assembly on the floor with the M8x70 mm screws (4) as in Figure B.
5. Assemble the curved shower pipe (1) with straight pipe (2) letting the supply flexible hose (5) slide down into
the straight pipe. Secure the two pipes at their connecting point with screws (12), Figure D.
6. Screw supply flexible hose nut (5) on the on/off valve body (13), then fasten the cover plate (9) with M4 screw
(12) as in Figure D.
7. Align the straight and curved tubes (1 & 2) (an adjustment range ±5° allowed) and tighten the M4 adjusting
screws (11).
8. Connect water supply pipe to the water inlet (1) as illustrated in Figure E.
Where outdoor showers are fitted with self-closing on/off valve, the time adjusting screw is set by manufacturer.
Gradually turn the adjusting screw clockwise or counterclockwise, until the desired flow time is achieved. Time
adjustment can bet set with a min. of 1 second and max. of 40 seconds.
IMPORTANT!! DO NOT FORCE THE SCREW CLOCKWISE, THIS CAN DAMAGE THE ADJUSTING MECHANISM
We recommend that you follow the maintenance instructions below to ensure that your product is safeguarded
during the winter months.
1. Empty the water supply that services the shower column at the end of the summer, before it starts to get cold.
2. During the winter months, we recommend that you cover the column using the protective covering included,
to protect it from inclement weather and humidity or remove it. This is easy to do and will allow column to last
longer.
