As with any HVAC project, careful installation is
the key to a successful outcome. Time taken
during the installation process will be rewarded by
fewer call-backs.
The steps required to install the T-32-P thermostat
are as follows:
1. Read and understand this Installation
Manual and User Manual.
2. Mount the T-32-P.
3. Set the 8 system switches to match the
equipment application.
4. Wire the optional remote temperature
sensor(s) or devices.
5. Power the thermostat.
6. Set the Advanced Installer Setup
options.
7. Program and setup the T-32-P
thermostat. (Refer to the User Manual for
instructions)
8. Test heating, cooling and other
functions.
GETTING STARTED
INSTALLING THE THERMOSTAT
FIGURE 1
DISASSEMBLY
Insert a small coin (dime) in the release slot
located on the bottom of the thermostat. Gently
twist the coin to release the thermostat from the
subbase. Avoid twisting the case as this may
stress the LCD or bend the terminal connector
pins.
(Figure 1)
THERMOSTAT LOCATION
MOUNTING THE SUBBASE
The T-32-P should be installed in a location that
represents the ambient space temperature. Do not
install the thermostat in an area where drafts are
present, near the floor, behind doors or on an
external wall. Avoid placing the thermostat in areas
where the air movement is limited, affected by direct
sunlight or other areas not typical of the
temperature in the space.
When mounting the T-32-P, be aware that drafts
may travel down wall cavities and enter the back of
the thermostat through the control wire hole in the
wall. It is important to seal the hole to prevent any
drafts that might affect the internal temperature
sensor.
Pull the control wires through the large opening in
the thermostat subbase then level and mount the
subbase on the wall using the supplied anchors
and screws.
Use a properly sized screwdriver and land each
wire to its dedicated terminal.
Check to ensure that all wires are landed correctly
and dressed properly to prevent any shorts.
(Figure 2)
Refer to Typical System Wiring Diagrams in this
manual.
Do not over tighten the mounting screws as the
subbase may warp causing the improper
seating of the thermostat connecting pins to the
terminal blocks.
Do not over tighten the terminal screws.
MOUNTING
HOLES
FIGURE 2
3
