Jackson MSC 10A, Руководство по обслуживанию

Страница: 19 / 53

Problem: None of the automatic functions work (wash, rinse).
1. Start switch faulty. Check switch. Replace if necessary, see instructions page concerning replacement of switches in control panel.
2. Wire connections poor. Correct the connection.
3. Timer rinse or wash microswitch faulty. See instructions page concerning timer and motor.
Problem: Rinse does not work when manual rinse fill switch operated, but does work during automatic cycle.
1. Normally open contact on rinse fill switch faulty. See instruction page concerning replacement of switches in control panel.
2. Wire connection poor. Correct the connection.
Problem: Wash does not work on automatic cycle, but does on manual wash.
1. Normally closed contacts on wash switch faulty. See instruction page concerning replacement of switches in control panel.
2. Wire connections poor. Correct the connection.
3. Timer rinse or wash microswitch faulty. See instructions page concerning timer and motor.
Problem: Wash does not work when manual wash switch operated but does work during the automatic cycle.
1. Normally open contact on wash switch faulty. See instruction page concerning replacement of switches in control panel.
2. Wire connection poor. Correct the connection.
Problem: When master switch is turned on either it washes continuously or rinses continuously.
1. Timer motor faulty and cams are not turning holding it in the mode it is in. See instruction page on the timer & timer motor.
Problem: Wash tub water level continuously lowers.
1. Large overflow strainer not seated properly. Remove and insert with a slight twisting action.
2. O-ring in drain fitting is missing. Replace. See illustration on page concerning overflow strainer and drain o-ring.
3. Deposit build up on drain fitting or O-ring. Clean.
4. Bottom of overflow strainer (conical end of tube) bent out of shape. Replace strainer.
TROUBLESHOOTING SECTION (CONTINUED)
17