Jack W4 Series, Руководство пользователя

Страница: 44 / 58

3、下切刀组件相对位置调整( adjust the relative )
注意:下切刀组件安装前须先检查下切刀组件相对位置是否正确，是否有卡点。
当动刀运动到最右时，也就是下切刀组件初始状态时，动刀与定刀前端的啮合
距离为 0.5mm（图 7） 移动定刀调整动刀与定刀的相对位置，动刀与定刀啮合距
离 0.5-1mm，动刀与定刀平行（图 7、图 8）。
Note: The lower cutter assembly before installation must first check the relative
position of the lower cutter assembly is correct, whether there is a card point.
When the movable knife to the right, that is, under the initial state of the cutter
assembly, the movable knife and fixed knife front end of the engagement distance of
0.5mm (Figure 7) to move fixed knife to adjust the relative position of fixed knife and
fixed knife, movable knife and Fixed knife meshing distance 0.5-1mm, movable knife
and fixed knife parallel (Figure 7, Figure 8).
图 7(
Figure7
)