Jack JK-58420J, Руководство по эксплуатации и каталог запасных частей

Страница: 19 / 23

6/9
P 5 1
0~100 3 Presser foot lifting electromagnet per cycle opening time (ms)
P 5 2
1~800 100 Running delay time when presser footer comes down (ms)
P 5 3
0/1 1
Presser foot lifting function selection
0: no action 1: action
P 5 4
0~100 8 Presser foot lifting electromagnet per cycle closing time (ms)
P 5 6
0/1 1
Run to up needle position after Power on：
0: no action 1: action
P 5 7
0~600 100
Presser foot lifting electromagnet protection time 100ms
P 6 0
200~3000 2700
The maximum speed of constant sewing (Automatic test speed)
P 6 2
0~4 0
Special mode:
0: normal Mode
1: simply sewing mode
2: motor initial angle measurement (Do not remove the belt)
3: Automatically setting the pulley ratio by the CPU. (Synchronizer
is necessary and the belt not removed)
4: automatic test model 1 (It has needle stop position of automatic
test, running and stopping
5S)
P 6 6
0/2 2
2:open safety switch function；0：close
P 6 8
200~3000 2700 The maximum speed limit of the machine head
P 7 1
0~50 2
Slow release lifter level adjustment, the smaller values and the
faster quickly (OC open time)
P 7 6
1~500 60 Back sewing electromagnet full output time ms
P 7 8
1~359 120 Start angle
P 7 9
0~359 320 End angle
P 9 8
0~4 4 Voice volume
P A 2
0-1 0 Voice on or off
P A 5
0-2 0 0:machine start voice and press voice 1 machine start voice only 2
press voice only
P A 6
1~100 1 Stitch count function proportion setting
P A 7
1~9999 1 Stitch count set
P A 8
0~6 0
Stitch count function mode：
0：off
1:stitch count up, recounting after over the setting value；
2：stitch count down, recounting after over the setting value；
3： stitch count up, motor stop after over the setting value(use
S4 [152.INI] =CRS, or Key A to recount)
4： stitch count down, motor stop after over the setting value(use
S4 [152.INI] =CRS, or Key A to recount)
5: stitch count up, show error but motor not stop after over the
setting value(use S4 [152.INI] =CRS, or Key A to recount)
6： stitch count down, show error but motor not stop after over the
setting value(use S4 [152.INI] =CRS, or Key A to recount)
P A 9
1~100 1 Trimming count function proportion setting