iMeter
e) I have forgotten the password for my unit.
Hold down the reset button for 7 seconds. This will turn off the use password feature
for the web based interface. This will remain turned off until you hold the button down
for a further 7 seconds, or the unit announces
“Now turning off password checking”
.
f) How do I set up my routing table?
To set up the routing table, open a DOS window (start, run type
command
press
enter) and at the command prompt enter.
>route add 192.168.0.100 10.1.1.20
Where
10.1.1.20
is the IP address of the Ethernet interface on the PC that the
iMeter is plugged into, via the crossover cable.
Now ping 192.168.0.100 to see if the connection was successful.
g) How can I change my administrator password?
If you wish to make your unit more secure and change the administrator password
from the default (public) to your own choice follow these steps;
•
Log into your unit using the default password.
•
Point towards the settings tab.
•
Change the password
h) What function do the different types of notifications provide?
The notifications are used to notify you when a sensor reading has hit a certain preset
“critical” threshold. There are many ways you can be
notified. They are as follows;
SNMP Trap:
This form of notification sends out a signal to your SNMP server.
E-Mail:
This sends a notification via e-mail.
SMS:
This sends an SMS message to your mobile phone.
Relay:
The relay is used as a switch, for example it could switch on an air con unit if
the temperature reading of a temperature sensor reaches a certain threshold.
Speech:
Creates a text to speech notification.
Содержание iMeter Master
Страница 2: ...iMeter ...
Страница 40: ...iMeter LED patterns in Normal mode then LED patterns in Safe mode ...
Страница 41: ...iMeter then ...
