ASSEMBLY
1. Press new seal into bearing housing with lip
facing away from bearing bore.
(19)
2. Fit retaining rings onto shaft and press on
bearings.
(21,24)
3. Grease seal area of shaft, push bearings
and shaft into bearing housing by pressing
on outer race of bearings.
(10,20,22,25)
4. Fit adaptor housing to bearing housing,
secure with 3 bolts.
(14,15)
5. Fit field coil to adaptor using 3 bolts. Check
that centre bore of field coil fits over boss
on adaptor.
(16,17)
6. Wipe pump shaft to remove any particles and check location of key. Slide pulley assem-
bly onto shaft, lining with key and secure with retaining bolt.
(22,23,26,27,28)
7. Place slinger on shaft.
(9)
8. Fit pump body to bearing housing securing with 4 bolts.
(5,10,11,12)
9. Take new seal seat (cup rubber and seal seat), lightly grease the outside edge of cup
rubber and press into cavity in pump body with ceramic facing towards impeller bore.
10. Slide mechanical seal sub assembly over shaft until the carbon face engages against
the ceramic face of stationary seal.
(19)
11. Fit wearplate.
(4)
12. Coat cam screw threads, top side and back of cam, with non setting jointing compound
and fit into body, securing with the cam screws.
(6,7)
13. Lightly grease impeller bore and fit impeller.
(3)
14. Fit end cover and gasket, and secure with screws.
(1,2,18)
KEY
DESCRIPTION
QTY
KEY
DESCRIPTION
QTY
1
End cover
1
15
Bolt
3
2
Gasket
1
16
Field coil
1
3
Impeller
1
17
Screw
3
4
Wear plate
1
18
End cover screws
5
5
Body
1
19
Seal assembly
1
6
Cam
1
20
Bearing
1
7
Cam screw
1
21
Retaining ring
1
8
Pipe plug
2
22
Shaft
1
9
Slinger
1
23
Key
1
10
Bearing housing
1
24
Retaining ring
1
11
Washer
4
25
Bearing
1
12
Bolt
4
26
Washer
1
13
Inner bearing seal
1
27
Screw
1
14
Clutch adaptor
1
28
Pulley
1
