PERFORMANCE DATA
HEAD CAPACITY TABLE
Head Feet
GPM
Amps
Free Flow
14.0
14.0
5
13.0
14.5
10
11.5
15.0
15
10.5
16.0
20
9.0
16.5
** Flow rates and amperage will vary slightly depending on
pump loading (sanitation system design).
RECOMMENDED WIRE & FUSE SIZE
Wire Size for Connection
Length between Battery & Motor
Voltage
1–10'
10-20'
Fuse/Breaker*
12
12 AWG
10 AWG
20 amp
INSTALLATION INSTRUCTIONS
Locating the pump: The macerator is self-priming to a
six foot lift when impeller is wet, four foot when dry, and
may be mounted in any convenient point in the waste
discharge system. It may be mounted in any position or
angle without affecting performance. Use the rubber
grommets provided to absorb vibration. Do not over tighten
mounting screws. For optimal performance, mount the
pump as close to tank as possible.
Plumbing Connections: Use 3" ID non-collapsible hose
and clamp on outside diameter of macerator housing.
All suction connections must be airtight and free of sharp
bends or restrictions to ensure proper priming. Use
minimum 1" ID hose for discharge to direct waste to an
appropriate sewage receiver such as a sewer clean-out.
See recommendation on page 1.
Wiring Hookup: For permanent connection, use heavy
duty stranded copper wire to avoid excessive voltage
drop. Consult recommended wire and fuse size table for
correct size. Install 20 Amp fuse in positive lead between
power source and on-off switch for macerator.
NOTICE: Connect orange wire to positive circuit and black
wire to negative for proper rotation. Failure to connect wires
as described will damage unit and void warranty.
FROM HOLDING TANK TO EXTRA HOLDING TANK
Home Sewer Access
Toilet Bowl
18590-0010
Holding Tank
Sewer Drain
HOLDING TANK PUMP OUT - PERMANENT INSTALLATION
TYPICAL RECREATIONAL VEHICLE USES
