9
To install your Jabra LINK solution
Settings:
1. Install your headset solution to your desk phone according to the
headset manual.
2. Set “Clear dial tone switch” in “A” position - see headset manual.
3. Ensure your headset base unit EHS mode is setup to
DHSG
-
see headset manual*.
Connections:
4. With the cable included with your headset system, connect the
phone socket on your headset base unit to the phone socket on
your Jabra Link.
5. With the cable marked white
D
, connect the Headset / Handset
socket on your Jabra LINK to the 3,5 mm headset socket on the
side of your desk phone.
6. With the cable marked orange , connect the COM socket
on your Jabra LINK to the modular socket on your desk phone
marked with a “Bell” icon.
7. With the cable marked red , connect the AUX socket on your
headset base unit to the Jabra LINK AUX socket.
Note:
The marked end of each cable must be connected to the Jabra LINK.
* If your base unit does not support
DHSG
mode, RHL mode (GN default AUX mode) can be
used with limited functionality between phone and base unit – which means under installation
you may need to do hook ON and OFF a couple of times before phone and base/headset are in
sync. For RHL mode we recommend either to use your headset or phone to answer/end calls.
EN
