The JA-157P dual zone outdoor wireless motion detector - curtain
The JA-157P dual-zone outdoor wireless motion detector - curtain
2
MMY51701
No movement should be detected at this moment for less than a 1 m
distance. Then a 10 minute test mode runs. In the test mode pulses
are sent every 20 s, so detector covering is indicated at least 20 s
after covering starts. When test mode expires the detector goes to
normal mode. Then the pulses are sent every 3 minutes so covering
is indicated at least 3 minutes after covering starts. Covering is
indicated as detector tampering. Detection is restored at least 20 s
after the obstacle disappears. The function is disabled as default.
Options are adjustable by DIP switches inside the detector
Normal mode
test mode
Save mode 120s.
5s.
NC
Fault signal switches NO
LED OFF
LED ON
Increased immunity
Normal immunity
Anti-masking OFF
Anti-masking ON
Factory settings highlighted by
bold letters
.
1.
Test mode
: LED indication enabled; save mode completely
disabled (
DIP switches 2 and 4 don´t matter);
Normal mode: DIP switches 2 and 4 are included.
2.
Save mode: Detector goes to sleep mode 5 or
120 s
.
3.
Selection of output relay logic in standby mode (
NC
/ NO, for
combination with Jablotron systems use the option NC)
4.
ON /
OFF
LED indication of movement
5.
False alarm immunity
6.
ANTI-MASKING- see the paragraph Masking function
The detection part can be
turned by
190° with 5°
steps. When the required
angle has been set, use the
plastic lug to prevent further
movement. The angle is
fixed completely when the
cover with the lenses is put
back and the screw is
tightened.
Checking the status of and replacing batteries
The detector checks the battery status and automatically reports a
low battery to the system. The detector remains fully functional. The
battery should be changed as soon as possible (within 1 week).
The control panel must be in service mode or bypassed by the
system Administrator
before you start changing the battery
. Use a
CR123A 3 V battery only. When the cover has been closed, the
detector switches to the test mode.
Note:
If you insert a nearly drained battery into the detector by
mistake, the sensor does not start working and this status is indicated
with the transmitter LED flashing. If the battery is completely drained,
the detector does not react at all.
Technical specifications
Power
1x type CR123A (3 V / 1500 mAh) lithium battery
Typical battery lifetime
approx. 3 years (with 120 s save mode)
Communication band
868.1 MHz, JA-100 protocol
RF range
up to 300 m (open area)
Optex detector parameters
Detection characteristic
2 or
5 m / 5°
Detector installation height
0.8
– 1.2 m
Object motion speed
0.3
– 1.5 m / s
Detector cover conformance
IP55
Environment according to EN50131-1
IV
Operational temperature range
-
20°C to +60°C
Max. relative humidity
95 %
Dimensions (mm)
power supply with transmitter 34x154x43
detector 34x 154x43
Weight
190 g
Security grade
according to OPTEX
Complies with
ETSI EN 300 220, EN 50130-4,
EN 55022, EN 60950-1
Can be operated according to
ERC REC 70-03
JABLOTRON ALARMS a.s. hereby declares that the
JA-157P
is in
compliance with the essential requirements and other relevant
provisions of Directive 1999/5/EC. The original of the conformity
assessment can be found at
Support section
.
Note: Although this product does not contain any harmful
materials we suggest you return the product to the dealer or
directly to the producer after use. For more detailed information
visit
