JR_EYE-02.ENG.MAN.Manual.16.A
- 15 -
Camera keeps more than 10% of free space on the memory card. Automatically deletes old files.
The SDmicro memory card also contains some esential data for camera. In case you replace your
card with another one always use Jablotool to restore data structures.
5.7 Reset to Factory Defaults
If necessary, the EYE-02 camera can be RESET to the factory default settings following this guide:
Warning: All user settings, contacts and events will be deleted! Memory card will be formated.
Events an files downloaded into the JabloTool DESKTOP software remain in PC.
• Switch off the camera, remove the battery
• Wait at least 10 seconds
• Press the power button and while holding it, do the following steps.
• Insert the battery
• Within 10 seconds connect the AC power adaptor
• Camera starts producing fast beeps
• Wait until the camera makes 3 longer beeps and both LEDs (R+G) start flashing. Release the power
button.
• Camera resets and restarts into the ENROLL mode.
5.8 External Wireless Devices
The EYE-02 camera has a built-in short range radio transceiver, which allows communication with a wide
range of professional security wireless devices from OASiS system produced by JABLOTRON ALARMS (see
www.jablotron.com
).
This is a very simple way to extend your camera function to provide additional services such as:
• heating control by a mobile phone
• PANIC button function for elderly or disabled people.
Refer to the table on the inside back cover page of this manual for a brief review of available types of wire-
less devices.
For enrolling a new device use JabloTool software (EYE-02/Configuration/External devices/Add new device)
or switch the camera to the
ENROLL mode.
For installing all wireless components follow their manual.
• Remote controls / panic buttons: switch the camera to the
ENROLL mode
, press any button on the
remote control.
• Detectors: switch the camera to the
ENROLL mode
, insert the battery in to the detector.
• JA-80L Siren: switch the camera to the
ENROLL mode
, plug the siren to the wall socket.
• JA-80A Siren: switch the camera to the
ENROLL mode
, connect the battery in the siren socket.
• AC-82 Wireless relay: switch the camera to the
ENROLL mode
, follow the manual of AC-82. For activating
the transmitter of EYE-02 press the power button on the camera shortly.
Once the camera is enrolled into the wireless relay, you can choose function of the relay outputs. Outputs
can be managed by an SMS, can signal the mode of camera, etc. For settings go to JabloTool EYE-02/Configu-
ration/External devices/ Programmable outputs.
For more information about wireless devices see application notes on www.jablocom.com
Содержание EYE-02
Страница 1: ...GSM Security Camera EYE 02 Security Camera...
