2
3
1
Remove the screw, which is fixing
the hand wheel.
Remove the 8 screws, which are fixing
the body to the cover of the actuator.
Carefully lift the cover.
Carefully remove the position indicator.
6
Fix the plastic column
(
Element
B)
on the base plate, by using
2 sheet metal fixing screws
(
Element
D)
(Fig. A,B and C).
A
B
C
8
Mount the DPS positioner PCB
(
Element
C)
, matching the cleft
of the shaft with the key inside the DPS gear.
9
JP3
JP2
Press the DPS positioner PCB
(
Element
C)
along the shaft until the PCB
connector (JP3) is plugged in the actuator PCB connector (JP2).
10
Fix the DPS positioner PCB
(
Element
C)
to the plastic column
(
Element
B)
with the
plastic fixing screw
(
Element
E)
(Fig. A). Connect the remaining cable
(
Element
A)
to the connector base on the DPS PCB
(
Element
C)
(Fig. B).
A
B
Fix the cover to the body by using the 6
screws.
Carefully mount the cover, minding the cables
not to be pressed.
Mount the hand wheel on the shaft and fix
it by using the screw.
14
15
Mount the 3 outer connectors together with its rubber joints and fix
them to the cover, by using the screws.
Outer Set-Up: Only if necessary.
- B plug - Connect a cable between PIN 1 and PIN Earth.
- A plug - Connect it to the power supply.
- B plug, disconnect the cable between PIN 1 and PIN Earth.
The actuator will make a complete maneuver.
Connect B connector to the actuator. The actuator is ready to work.
17
PIN 1
A
B
16
11
Carefully insert the position indicator, matching its inner key with the cleft of the shaft.
13
Use the configuration you need by
moving the DIPs, according to the
instrumentation signal:
In order to set the actuator up, use the DIPs shown in the picture. Put DIP 1 in ON position (Fig. A),
connect the grey connector to the power supply (Fig. C). Put DIP 1 back to the prior position (Fig. B).
Wait until the actuator make a complete maneuver.
12
A
C
B
Remove the cables (from the cover) connected to the actuator PCB (Fig. A, B and C).
4
A
B
C
Take the DPS cover
(
Element
A)
and connect its cables, following (Fig. A,B and C).
7
A
C
B
5
10
