3.3
4.2
4.1
3.5
3.7
3.6
STEP 3 (TAILGATE SIDE)
*** Make sure zippers are zipped completely shut
**You will need a drill with 5/32” drill bit and 2 of (F). 4 of E.
1. Lower UTV bed
2. Pull J-Top cover over both corners of the tailgate
(Fig. 3.2)
3. Mark above the tail light for E and attach the snap (E)
(Fig. 3.3
4. Repeat on the other corner
5. Grab the J-top cover in the center and pull down firmly,
and mark the two center eyelets
(Fig. 3.5)
6. Drill the holes with 5/32” drill bit, then screw in F
(Fig. 3.6)
7. Mark last snaps and screw in E
(Fig. 3.7)
STEP 4 (SIDES)
**You will need a drill with ¼” drive ph2 bit and 8 of (E)
1. Mark each button on top rim of the bed
(Fig. 4.1)
2. Screw E into each mark and snap the cover onto the buttons
(Fig. 4.2)
3. Repeat on all 8 snaps until assembly is finished
STEP 5 (STORAGE)
1. Take off your UTV cover by unsnapping the snaps and place the
cover flat on the ground.
(Fig. 5.1)
2. Detach your frame and place all parts into the center of the cover.
(Fig. 5.2)
3. Fold the cover in half by lining up the handles together, you will
then snap 2 snaps together from each side of the cover.
(Fig. 5.3)
4. Pick up, carry, and hang by the handles for easy storage.
(Fig. 5.4)
3.2
COMPACT
Visit
www.j-toputvoutfitters.com
for an instructional video.
INSTRUCTIONS
CONTINUED...
5.1
5.2
5.3
5.4
Email: [email protected] • Phone: (270) 205-8371
