2 |
P a g e
J Tech Photonics, Inc.
Pic-
Convert™ Board Instructions V2
.7
Copyright 6/13/17
Power Specifications
The Pic-
Convert™ comes
with a provided 7V power adapter. If you want to use a different power
supply, the board requires a voltage higher than +6V. You can use a power supply that is larger (up to
24volts), but make sure the regulator does not get too hot. A 9V or 12V supply should be easy to find.
Connection Overview
INPUTS (left side of the board):
Dir :
Direction encoder signal for the axis chosen in control software.
Direction - :
Connect to the GND signal for your Breakout board or controller.
Step + :
Step encoder signal for the axis chosen in control software.
STEP - :
Connect to the GND signal for your Breakout board or controller.
Output :
This will enable the output of PWM or Analog on the OUT header.
Output Enable - :
Connect to the GND signal for your Breakout board or controller.
OUTPUTS (right side of the board):
OUT:
Output for the PWM (or analog) signal.
