Twister 3D Storm
ASSEMBLY
1.
UNPACK YOUR TWISTER 3D STORM
•
Carefully remove the model and other
items from the packaging.
•
Inspect the model to check that nothing is
damaged and that all components have
been included.
2.
ALIGNING THE TAIL BOOM & FIN
•
Check that the tail gearbox is perpendicu-
lar to the main rotor shaft.
See
below:
•
Check the tension of the tail drive belt.
Push on the drive belt with the tip of a
small screwdriver. You should be able to
push the belt inwards by approximately 2
to 3mm. See below:
•
Secure the tail boom by tightening the four
retaining screws on the main frame.
See below:
•
Rotate the horizontal fin into position mak-
ing sure that it is perpendicular to the main
rotor shaft. See below:
•
Tighten the retaining screws on the hori-
zontal fin to secure in place.
See below:
http://www.jperkinsdistribution.co.uk
http://www.modelengines.com.au
