Bill acceptor:
•
Bill acceptor comes pre programmed from J.E. Adams and should not require any
changes. If additional programming is needed to acceptors please refer to
additional literature sent along with this unit.
Display:
•
Unit may be programmed when received depending on information given at that
the time of order.
•
To program follow the instructions below.
Display programming with remote:
1)
Press the red power button.
2)
Timer will display 0000. At this time type in 4 digit access code. Note code will be
1234 until changed by customer.
3)
Once code has been entered display should read ok. If display does not read ok,
repeat step 1 and 2.
4)
Press
CH +
button. Timer will display coin value. This should $.25 and should not
be changed.
5)
Press the
CH +
button. Display will now read (
A: 30
) or may be a different time.
(
A
) Will be the time per coin for the
VAC
. Set desired time per coin by using the
VOL –
to decrease or the
VOL +
to increase. Once time is entered move to next
step.
6)
Press the
CH +
button. Display will now read (
B: 30
) or may be different time.
(
B
) Will be the time per coin for
TURBO
. Set desired time per coin by using the
VOL –
to decrease or the
VOL +
to increase. Once time is entered move to next
step.
7)
Press the
CH +
button. Display will now read (
C: 30
) or may be different time.
(
C
) Will be the time per coin for
SHAMPOO
. Set desired time per coin by using
the
VOL –
to decrease or the
VOL +
to increase. Once time is entered move to
next step.
8)
Press the
CH +
button. Display will now read
D
.
D
is not used.
9)
Press the
CH +
button. Display will now read
E
.
E
is not used.
10)
Press the
CH +
button. Display will now read
F
.
F
is not used.
11)
Press the
CH +
button. Display will now read (on A). This is the number of coins
to start
VAC.
Use the
VOL –
and
VOL +
to adjust. Once this is done press the
CH+
button and repeat for (B)
TURBO
and (C)
SHAMPOO.
12)
Press the CH + button. Display will read bonus time. Set if desired. See
explanation at the end programming instructions.
13)
Press the
CH +
button. Display will debit mode. Set if desired. See explanation at
the end programming instructions.
14)
Press the
CH +
button. Display will delayed start. Set if desired. See explanation
at the end programming instructions.
15)
Press the
CH +
button. Display will read
HLxx
. Set if desired. See explanation at
the end programming instructions.
16)
Press the
CH +
button. Display will read Restart off or restart on depending on
what is set. Restart off will require a person to put in full amount after unit is
6
