Battery Replacement
The SolarBee contains an onboard battery located
in the electronic controller that will require infrequent
replacement. Between 2 and 3 replacments are
expected over the course of the machine life.
TOOLS RECOMMENDED:
NO TOOLS REQUIRED:
STEP 1:
Open the solar panel stand access panel
located opposite side of the solar panel.
STEP 2:
Locate the electronic controller and the On/Off
switch. Turn the switch to the "OFF" position.
STEP 3:
Refer to proper Power Down Procedure
located in the Electrical Section.
STEP 4:
With the SolarBee off, unscrew the battery
lead from the battery terminal.
STEP 5:
Slide the battery out of the panel stand box.
IMPORTANT NOTE:
The battery weighs approximately 140 lbs and
may require two people to handle.
STEP 5:
Install new battery into position and connect
battery lead back up to the battery terminal.
STEP 6:
Refer to the proper Power Up Procedure
located in the Electrical Section.
STEP 7:
Turn the On/Off switch back to the "ON"
position.
STEP 8
: Be sure the SolarBee is operating correctly
and close the access panel.
Battery Disposal: Be sure to follow local
law and regulations when disposing of the
used up battery!
Solar Panel Stand Open With
Controller And Battery
Battery
Electronic Controller
DIGITAL
CONTROLLER
ON / OFF
SWITCH
* * Failure to follow these steps could
result in component damage. * *
©2021 IXOM Watercare Inc. | www.ixomwatercare.com | 866 - 437 - 8076 | [email protected]
Maintenance
Battery Replacement
SB Series Potable Water
2086_10274_20210729
O&M_SB2500PW_10248_20211110 - 32
