IXIA IxOS, Руководство по установке

Страница: 19 / 36

System Interface
Figure: Front Panel, Application Server
Overview
There are several LEDs on the control panel to keep you constantly informed of the overall status of
the system as well as the activity and health of specific components. There are also two buttons on the
chassis control panel.
Control Panel Buttons
There are two push-button buttons located on the front of the chassis. These are (in order from left to
right) a reset button and a power on and power off button. The front panel controls and indicators are
described in
Table: Front Panel Controls & Indicators .
Control / Indic-
ator Description
Reset Reboots the system.
Power Main power switch, which is used to apply or turn off the main system power.
Turning off system power with this button removes the main power but keeps
standby power supplied to the system.
Overheat/
Fan Fail
When this LED flashes it indicates a fan failure. When on continuously, it
indicates an overheat condition, which may be caused by cables obstructing
the airflow in the system or the ambient room temperature being too warm.
Check the routing of the cables and make sure all fans are present and oper-
ating normally. Also check that the chassis covers are installed. This LED
will remain flashing or on as long as the overheat condition exists.
Table: Front Panel Controls & Indicators
Chapter 1 Ixia Application Server Installation
IxOS Application Server Installation Guide 9