iXBlue MBC-AN-LAB, Руководство по эксплуатации

Страница: 11 / 20

MBC-AN-LAB 10 Version 2.0
Installation: Install the USB driver (PhotlineUSBinstaller.exe), and then launch the
setup.exe present on the CD.
The MBC interface software is now installed and ready to be used.
Operation
Quick start procedure
Your MBC-AN-Board has been carefully mounted so that you just need to set the
correct adjustments with the windows interface to get going. You basically just need to plug
the +12V/0/-12V supply (<3> or <4>) and connect the inputs (<1> and <2>) and the outputs
(<9>). You will find a quick start procedure below:
1. Make sure you received all the ordered parts
2. Proceed to the MBC-AN-Board system installation
3. Connect the board to the power supply
4. Connect the PD2 output connector (Signal) to a power meter using an optical fiber.
Then plug the modulator output connector to the PD2 input connector. Plug the
modulator input connector to the PD1 output connector. And plug the laser connector
to the PD1 input connector. Connect the Vbias connector to the modulator Vbias pin,
and the ground connector to the modulator ground.
Setup with an internal coupler (coupler option):