HU
EN
2-4.
Checking
1. Whether the machine is connected to standard to earth.
2. Whether all the connections are well-connected. (esp. that between the earth
clamp and the work piece)
3. Whether the output of the electrode holder and earth cable is short-circuited.
4. Whether the pole of the output is correct.
5. The
welding splash may cause fire, so make sure there is no flammable materials
nearby.
2-3
Connect the wire feeder
1. The long axis of the wire feeder lock the wire roller that specific wire. Make sure that
the wire roller is suitable for the wire used!
2. Wire should roll down clock wise, then cut the line, off-stage, it is only after pinning it
on!
3. Tighten the hold-down screws on the wire, put the wire into the wire feed guide
wheel and thread the wire to the welding torch.
4. Press the button on the wire feeder to the welding torch into the wire.
Power indicator
Protection
indicator
MIG/MMA function
switch
Welding current Welding voltage
Wire speed
Electronic
Choke control
Voltage meter
Current meter
Power switch
Operation mode
switch
Wire feeder
button
7
