Iwata SMART JET IS-850, Инструкция по эксплуатации

Страница: 5 / 11

5
6. Place the moisture trap into the compressor’s front-mounted metal ring. The moisture trap should snap into place. By snapping into place
it will not rattle when the unit is running.
7. The airbrush should fit into the black airbrush holder by placing the front end of the airbrush into the holder. If using a bottle feed airbrush
with the bottle attached, put the back end of the airbrush into the holder.
8. Plug the compressor into a grounded wall outlet. (Avoid using an extension cord.)
9. Turn the compressor ON by pressing down the switch on top of the unit. The unit will run for a couple seconds then stop. This is OK! When
you push down the trigger on your airbrush, the compressor will come on and when you release the trigger the unit will stop. This is the
Auto Shut-Off feature effect. This feature will prolong the life of your motor since the unit doesn’t run the whole time it’s turned on.
10. As the unit is being used, water may collect in the moisture trap’s clear, plastic bowl.
11. Release the water by twisting the dial toward the – sign.
a. This will open the bleed valve and drain off the collected moisture.
b. Do not let excess water build up in the moisture trap.
c. Hold a paper towel under the open valve to collect the water.
d. Once water is drained, close the bleed valve before using the compressor again.
GETTING STARTED (CONTINUED)