IVT HMC300, Руководство по эксплуатации

Страница: 10 / 44

10
Quick manual
HMC300 – 6 720 813 192 (2014/10)
4.3 Change room temperature
Use Result
If you are cold or think that it will be too hot: change the room temperature temporarily
Automatic mode
Change room temperature to next break point
▶ Turn the menu dial to set the required room temperature.
The period in question is shown in grey in the time program bar chart.
▶ Wait a few seconds or press the menu dial.
The control unit works with the new setting. The change applies to the next break
point in the time program for house heating. After this the settings in the time
program apply again.
Undo temperature change
▶ Turn the menu dial until the time period is shown in black in the time program bar
chart, and then press the menu dial.
The change has been cancelled.
If you are always cold or think it is too hot: set the required room temperature (e.g. for heating and temperature reduction
mode)
Optimised operation
▶ Activate optimised operation (

chapter 4.2).
▶ Wait a few seconds or press the menu dial to close the popup window.
▶ Turn the menu dial to set the required room temperature.
▶ Wait a few seconds or press the menu dial. Confirm the change in the popup
window by pressing the menu dial (or cancel the change by pressing the return
button).
The actual room temperature is shown in the bottom half of the display, in a
popup window.
The control unit works with the new settings.
Automatic mode
▶ Press the menu button to open the main menu.
▶ Press the menu dial to open the menu
Heating/Cooling .
▶ Turn the menu dial to mark the menu Temperature settings .
▶ Press the menu dial to open the menu.
▶ If two or more heating circuits are installed: turn the menu dial to mark
Heating
circuit 1 , 2 , 3 or 4 and press the menu dial.
▶ Turn the menu dial to mark Heating , Setback , Increase or Cooling .
▶ Press the menu dial.
▶ Turn the menu dial and press to activate the required setting e.g. for
temperature reduction mode.
When the temperature adjustment is activated:
▶ turn the menu dial and press it to set the temperature. The limit for the values set
for temperature depend on the settings for the other operating mode.
The control unit works with the new settings. The settings apply for all time
programs for house heating (when two or more heating ciruits are set they only
apply to the selected heating circuit).
Table 6 Quick guide – Room temperature
6 720 811 136-05.1O
6 720 811 136-06.1O
6 720 811 136-07.1O
6 720 811 136-08.1O