35mm 38mm 40mm
A
B
C
D
Fold and align along door edge
60mm
42mm
DOOR THICKNESS
Drill Ø25mm hole
57mm deep at centre
of door edge
CUT ALONG DOTTED LINE
Drilling Template
1.1.
Mark the edge of
our door at the
desired height of
our handle. (Figure 1)
1.2.
We recommend
around 900mm –
100mm from
fl oor level, or at the
centre of a lock rail
on a panel door.
1. Marking the Door
Preferred product height
Figure 1.
2. Install Latch & Striker Plate
As per supplier instructions, resources available
at iver.com.au/resources.
Figure 2.
1.3.
Using a spirit level, mark
the door at the desired
lever height, continuing
the line from the front of
the door, around the edge
and onto the back of
the door. (Figure 2)
1.4.
We recommend extending
the line 100mm onto
each face of the door.
3.1.
If required, shorten cut-off screws to suit door
thickness.
3.2.
Ensure to cut so that the screw does not protrude
from the opposite rose once installed. (Figure 3)
3. Prepare Cut-off Screws
—
if using face fi x timber screws, proceed to step 4
4.1.
Place the split spindles into the latch from either
side of the door.
4.2
. Unscrew the outer roses from the door lever set
(for square rose hardware loosen grub screw and
remove) and install the halves on either side of
the door, ensuring the levers function in the
correct direction.† (Figure 4)
4.3.
Insert two of the cut-off screws through non-
threaded holes of the inner rose at 3 and
9 o’clock, screwing them into the opposite rose.
Repeat at 12 and 6 o’clock,
OR
(Figure 5)
4.4.
Affi
x wood screws at all fi xing points.
4.5.
Replace outer rose cover.
4. Install Levers
Figure 3.
(6)
† For Helsinki lever unscrew end cap to remove and fi t rose.
(6)
(1)
(7)
Wood Screws
(5)
(2)
(1)
Figure 4.
Figure 5.
