Iveco DAILY 4x4, Инструкция по эксплуатации, Страница: 64 / 110

2-40
CHASSIS MODIFICATIONS D
AILY
4x4
Base - May 2007 Print 603.93.761
Changing the Size of the Tyres
2.15.3 Fitting pipes on the vehicle
New pipes must be thoroughly cleaned inside before use (e.g. by blowing through with compressed air).
Pipes shall be secured into their correct positions and the fasteners must fully wrap the pipes: they may be made either of metal,
with rubber/plastic protections, or plastic.
Figure 2.13 illustrates two examples of brackets complete with retaining clips, used to secure the brake pipes along the chassis.
Figure 2.13
102435
3 seats for pipes (diameter: 4
÷
6)
pipe diameter: 7.5
÷
8
pipe diameter: 4.8
When a pipe has to pass through the chassis frame (sidemember or cross members), appropriate precautions must be taken
to avoid damage.
Observe adequate distances between the various fixing elements. As a rule the maximum distance of 500 mm should be considered.
For plastic pipes, in order to prevent distortion and tension on the connectors when fitting them, take the necessary precautions
when arranging the pipe runs and fitting the fixing brackets or clips onto the chassis. Correct fitting of the fixing elements will ensure
that the pipes do not rub against the fixed parts of the chassis.
Observe the necessary safety distances from moving parts and heat sources.
!
Important!
After completing any work either on the system or on the equipment, the air must be bleed from the
system correctly, following the instructions given below. The braking system must then be checked
for correct operation and efficiency.