CARE & MAINTENANCE
10
CARE & MAINTENANCE
1. While the UNLOCK/LOCK button is held, slowly squeeze down on the
trigger to use the washer. Then, take suction hose out of the water.
2. Continue to squeeze trigger to relieve pressure from nozzle. After a few
seconds, release the trigger.
3. Detach the nozzle from the washer then unlock and squeeze the
trigger again. Squeeze the trigger for a few seconds to let remaining
water come out.
4. Detach suction hose from the washer. Then, allow remaining water to
drain out of the hose.
Draining Water from Washer
1. Pour about 0.8 gal (3 L) of antifreeze into a water tank.
2. Attach the battery pack, nozzle, and suction hose to the washer.
3. Unlock the trigger and squeeze it until a steady stream of antifreeze comes out.
4. Release and lock the trigger when finished.
Adding Antifreeze
1. Detach battery pack from the washer.
2. Connect the battery pack to the battery charger. Then, connect the charger
to a power outlet.
NOTE: Battery will charge for about 3.5 - 4 hours to reach full charge. Make sure
to charge the battery before and after using the spray gun for the best performance.
Charging the Battery
1. Follow steps in the “Draining Water from Washer” section.
2. Then, run fresh water through the washer before using.
To Remove Antifreeze:
