1
6
10
11
13
12
7
8
9
2
3
4
5
Hardware
1. Unit
adapter
2. Exhaust
hose
3. Window slider adapter
4. Bolt
5. Window slider A
6. Window slider B
7. Adhesive foam seal A (2)
8. Adhesive foam seal B (2)
9. Foam seal C
10. Security bracket
11. Screws (2)
12. Drain hose
13. Remote controller with 2 AAA batteries
Safety precautions
•
Only use the included accessories and parts. Using non-standard parts may increase the risk of leakage, electrical shock, fire,
injury, or damage to the unit.
•
Always use a grounded outlet with the appropriate voltage.
•
Only install the unit onto a flat, sturdy surface, or risk excessive noise and vibration.
•
Do not block the intake or outlet vents.
•
Do not modify the length of the power cord or use an extension cord to power the unit.
•
Do not share a single outlet with other electrical appliances. Risk of fire or electric shock.
•
Do not install the unit in an area where it may become wet or damp. Risk of short circuit.
•
Do not install the unit in a room where it may be exposed to combustible gas. Risk of fire.
•
Do not roll the unit over other objects or thick carpet or risk tipping the unit over.
•
Do not operate the unit if it has been dropped or damaged.
•
Keep out of reach of children and pets.
•
If the unit is knocked over during use, turn off the power immediately and unplug it from the power supply. Check the unit for
damage before turning on again.
•
This appliance is not intended for use by children or people with reduced physical, sensory, or mental capabilities or lack of
experience and knowledge, unless they have been given supervision or instruction concerning the use of the appliance by a
person responsible for their safety.
•
Do not use the unit if the power cord is damaged.
•
Always disconnect the unit before performing maintenance.
•
Do not run the power cord under carpeting, rugs, furniture, or other coverings.
Installation Setup
Before installing the unit, be sure to have the following tools:
a. Medium Phillips screwdriver
b. Tape measure or ruler
c. Knife or scissors
1. When choosing an appropriate location to install the unit, keep in mind
the
following:
a. The surface should be flat and even.
b. It must be near a grounded plug.
c. The collection tray drain must be accessible.
d. The unit should be at least 12” (30cm) from the nearest wall to ensure
proper air conditioning.
e. Do not cover the intakes, outlets, or remote signal receptor.
3