5
Phoenix Ionizing Blower
5200632 Rev. E
4. INSTALLATION
Positioning and Mechanical Requirements
1. For maximum effectiveness, position the Phoenix as close as possible to the charged
surface to be neutralized. Direct the air stream longitudinally, and in the same
direction as, the target material movement to maximize the time the charged surface
remains in the air stream. Ensure that the ionized air stream covers the entire
target surface, and that the material to be neutralized is not in direct contact with a
background surface.
2. The Phoenix can be placed on any flat, level surface using the built-in bench stand.
It can also be wall or ceiling mounted using the tapped mounting holes in the base of
the stand. The Phoenix may also be placed on an OPTIONAL vertically adjustable
floor stand that can be moved and positioned as required.
Electrical Connections
1. The Phoenix requires 120 VAC, 60 Hz or 230 VAC, 50/60 Hz for operation.
Depending on the model, terminate line cord with plug if required. Connect the line
cord to a 3-terminal grounded receptacle.
2. The unit MUST be grounded for ionization to occur.
NOTE
– Do not attempt to operate at voltages other than those specified.
NOTE
– For 230 VAC, 50/60 Hz units, performance is slower for 230 VAC
50 Hz operation by approximately 20%.
CAUTION – Fire Hazard
Do not install or operate equipment in close proximity to any flammable solvents
or in explosive atmospheres.
