ITT Bornemann SLH-4G, Руководство по эксплуатации

Страница: 60 / 78

7 Maintenance and repairs
Trained customer service engineers from ITT Bornemann GmbH
are available for installation and repairs. Upon request, present veri-
fication for the pumped material – DIN safety data sheet or declara-
tion of no objection (
Ä
Chapter 9.2 ‘Declaration of no objection’
on page 74).
DANGER!
Mortal danger due to explosion!
Observe the additional ATEX instructions!
WARNING!
Risk of injury due to unprofessional work!
– Only allow work to be carried out by technical specialists who
have the required knowledge and practical experience to do so:
–
Installation, initial commissioning, repairs, maintenance,
– Work on the electrical and electronic systems.
– Make personal safety equipment available.
– Observe statutory or other safety and accident prevention regu-
lations.
n Use original parts or parts approved by ITT Bornemann GmbH exclusively.
n Spare parts lists and repair instructions on request, where not included in the
scope of supply.
7.1 Wearing parts
Wearing parts have a limited shelf-life because of their functionality and are there-
fore not subject to the warranty.
Regarded as standard wearing parts are:
n mechanical seals,
n gaskets,
n roller bearings,
n radial shaft seals,
n O-rings,
n gland packings.
Regarded as long-term wearing parts are:
n shafts and conveyor screws,
n casing insert.
7.2 Monitoring
The test intervals are dependent on the pump loads.
Information about automated monitoring functions System docu-
mentation.
Maintenance and repairs
Type SLH-4G, SLHS-4G 60
01/2016 JPB Rev. 5