ITS Telecom PanDoor, Инструкция по установке и программированию

Страница: 19 / 29

Programming
14 PanDoor Installation and Programming Manual
3 Programming
PanDoor programming is performed via a telephone using DTMF
commands.
Operational keys:
Operation Command Comment
Connect to panel #1 – connect to panel 1
#2 – connect to panel 2
Connect to
controller #9 – connect to
controller
Use this option for
programming
operation
Open door 8 You may modify
this code (*150)
Switch between
active PSTN /Panel
session 0 – switch between
PSTN/Panel as response
to waiting call tone
You may modify
this code (*160)
To enter the programming mode:
1. Pick up the receiver of the residential telephone and make sure
that you receive the PSTN dial tone.
2. Call the required unit (#1 for outdoor panel 1, #2 for outdoor
panel 2 or #9 for indoor controller unit).
3. Wait until a connection indication signal sounds (two fast
beeps).
4. Dial the following:
*900+password
.
5. Start the programming procedure according to requirement.
Every successful command is confirmed by two consecutive
beeps. An error is indicated by a single beep.