ITS Partner O.B.S S.L · Av. Cerdanyola 79-81 Local C
08172 Sant Cugat del Vallés · Barcelona (Spain)
Phone: +34935839543 · [email protected] · www.ek.plus
14
USER MANUAL
CCA
6.2.6. Cloning of controllers
ATTENTION CLONING CAN ONLY BE DONE WITH 12 VDC NOT IN AC. CLONE SO THAT THE CCA IN
WHICH THE CONFIGURATION IS TO BE DUMPED (THE RECEIVER) IS NOT VISIBLE FROM THE
CONTROLLER, SAVE IT IN A DRAWER OR COVER IT IF NECESSARY.
The controller may be cloned to another CCA controller. The copied data are the configurations of the
transmitter controller and the registered user cards.
Make the following connections:
Apply the following steps to the unit to clone (transmitter):
Step 1
Enter in the programming mode
< Master code >
Paso 2
Start the transfer
9 6
Paso 3
Wait until the transmission ends
The green LED blinks
Step 4
Exit the programming mode
Note that:
•
Both units must have the same master code.
•
A cloning process with 1000 registered users may last up to 3 minutes.
•
Check connections. Avoid short circuits.
