ITS Telecom CGW-T4, Инструкция по установке и программированию

Страница: 10 / 19

CGW-T4 Installation and Programming Manual
- 8 -
4.2 CGW-T4 Installation
To install the CGW-T4 unit, perform the steps as follows:
ƒ
Mount the CGW-T4 unit in the 19-inch rack or on the wall by using installation brackets
or place the unit on the horizontal surface.
ƒ
Connect the antennas into the ‘Ant.’ SMA connectors on the front panel of the CGW-4
unit.
ƒ
Connect the analog trunk interface of the PBX to the port sockets on the front panel of
the CGW-T4 unit.
ƒ
Connect the power supply to the CGW-T4 unit. The unit will start the initialization and
registration. At the end of the process, the LCD’s will display the signal status of each
cellular channel.
NOTE
Adjust the antenna location until an optimal signal level is received. The signal
level indicates on the LCD display.
Figure 4. CGW-T4 Schematic Setup displays the schematic setup of the CGW-T4 unit.
PBX
PBX
extensions
PBX analog
Trunk interfaces
FXS Analog
Phone
Wall Power
Figure 4. CGW-T4 Schematic Setup