ITRON OpenWay OWR-1000-001, Руководство по установке

Страница: 16 / 22

Chapter 2 Installation
4. Watch the amber LED to verify the signal quality of the connection between the range
extender and the CENTRON meter.
To maintain a reliable connection, the radio link between the range extender and the
CENTRON meter must have sufficient signal quality. After the establishing a
connection, the range extender indicates the relative signal quality by the number of
amber LED blinks.
LED
color # of
blinks Definition Action
Amber
1
Poor signal quality. Relocate the range extender and return
to step 2.
Amber
2-5
Acceptable signal quality. No action is needed.
Three to five blinks are the best signal
quality, but two blinks is usually
acceptable.
5. Perform the procedure Link to the 2.4GZ OpenWay Gas Module on page 10.
Link to the 2.4GZ OpenWay Gas Module
Important Perform each procedure in the order listed in the Installation Checklist
on page 5.
The radio link from the range extender to the CENTRON meter must be established
before you establish a link to the gas module.
You have a limited period of time to complete the setup and verification of the radio link
between the range extender and the gas module. The time available depends on the time
setting configured in the range extender's install window parameter. The install window
parameter default setting is 10 minutes.
To set up and verify the radio link to the gas module
1. Go to the gas meter with the 2.4GZ OpenWay Gas Module and use the Itron magnet
to activate the gas module's radio joining process. Refer to the
2.4GZ OpenWay Gas
Module Installation Guide for complete instructions.
LED
color # of
blinks Definition Action
Red
3
The gas module is scanning for a
device to join. No action is needed.
Red
5
The gas module is joined to the
range extender. No action is needed.
10 DRAFT OpenWay Installation Guide