4. Center the mount body in the hole.
5. Ensure that the rubber O-ring is pressed into the groove in the brass nut and thread the nut
onto the mount body.
6. Finger-tighten the nut and then use a wrench to tighten the nut until the O-ring is
compressed. If the mount body spins while you are tightening the nut, use a spanner wrench
applied to the two holes on the top of the mount body to hold it still.
7. Clean the surface of the vehicle around the antenna mount body.
8. Ensure that the gasket is properly set in the antenna base.
9. Thread the antenna base onto the mount body, making sure not to cross-thread the mount.
10. Continue tightening the antenna base until it seats to the vehicle.
11. Complete the cable routing to the IMR-FT in the vehicle and secure the cable.
Installing the Magnetic Antenna Mount
The magnetic antenna mount can be installed temporarily on the metal roof of the vehicle and
then removed as desired.
01 September 2020
815-0410-00
23
Itron Mobile Radio User Guide
Chapter 7 Installing the IMR-FT
