2
Hardware Installation
25
2.7.12 Wake-On-LAN Connector
The system board suppor ts the Wake-On-LAN function. This
function will allow the network to remotely power-on a Soft
Power Down (Soft-Off) PC. However, if your system is in the
Suspend mode, you can power-on the system only through an
IRQ or DMA interrupt.
To use the Wake-On-LAN function, you must enable the “Resume
on LAN” field in the Power Management Setup of the Award
BIOS. Your LAN card package should include a cable. Connect one
end of the cable to the wakeup header on the card and the other
end to location J15 on the system board. The network will detect
Magic Packet and assert a wakeup signal to power-up the system.
Refer to the add-in card’s manual for details. Note: Your LAN card
must support the remote wake up function.
Pin
1
2
3
Function
+5VSB (720mA)
Ground
WOL
Important:
The 5VSB power source of your power supply must support
≥
720mA (minimum).
