RECEIVER IT3R10
USER MANUAL
9
¡ATTENTION!:
THE OPERATIONS INDICATED IN FIG. 5-1 CORRESPOND TO THE
STANDARD RECEIVER. FOR SPECIAL MODELS YOU MUST CONSULT THE
OPERATIONS ASSOCIATED WITH EACH RELAY IN THE RELAY OUTPUT SHEET
PROVIDED WITH THE RECEIVER.
¡ATTENTION!:
CONNECTION SHOULD BE MADE SO THAT WHEN GENERAL
SWITCHING IS TURNED OFF, THE REMOTE CONTROL RECEIVER IS ALSO TURNED
OFF.
¡ATTENTION!:
AS A SAFETY MEASURE, IT IS IMPERATIVE TO MAKE SURE THE UNIT
IS EARTHED WITH THE CORRESPONDING PIN OF THE CONNECTOR.
Itowa will not be responsible for an inappropriate installation.
5.3. START-UP
Once the receiver is installed and connected, when the general switch of the machine is turned on, the
LED located on the front of the receiver set will light up, to verify its correct operation
The following steps will be done with the transmitter associated with the receiver:
Insert a charged battery into the transmitter set, release the STOP BUTTON and press the START
1)
button.
The remote control will start to work activating the stop and start relays of the receiver, and the
2)
general contactor will be locked. The LED
on the transmitter and receiver will start to flash and the
S1 LED on the receiver will be activated, indicating that the radio control unit is in working mode.
From this moment, if any button is pressed, the corresponding operation will be activated. The
3)
selected operation will remain active while the button is pressed.
To keep the radio channel free and to avoid the operator could accidentally leave the machine on when it
is not in use, the remote control is equipped with an automatic stop system. This system is activated after
180 seconds (it can be programmed) after not operating, sending a stop sequence to the receiver,
causing the machine to stop.