Receiver IT3G7R20
USER'S MANUAL
7
5. INSTALLATION AND START-UP
5.1. INSTALLATION OF THE RECEIVER
The receiver should be located in an easily accessible area so that it can be easily handled. The antenna
should be pointing towards the ground and in a protected place to avoid shocks.
In compliance with Royal Decree 171/2004 on the Coordination of Business Activities, you are reminded
that you must guarantee the safety conditions for the maintenance of the machine in question, especially
in terms of its accessibility and transit areas to the points where the operator must carry out his work
.
(1)
ATTENTION!:
IT IS VERY IMPORTANT TO CLOSE THE COVER OF THE RECEIVER
CORRECTLY IN ORDER TO ENSURE THAT IT IS WATERTIGHT, AS THE ENTRY OF
WATER CAN SPOIL IT. THE WARRANTY DOES NOT COVER FAULTS RESULTING
FROM IMPROPER CLOSING OF THE COVER.
Whenever the installation allows it, the antenna should be free of metal shields to achieve a better radio
link and avoid communication cuts.
Itowa is not responsible for improper installation.
5.2. CONNECTION
It is recommended to connect the receiver with a standardized multi-cable hose. This hose will be
connected to the receiver from one end via the strip on the base plate of the machine, while the other end
will be fitted with a multi-pin connector, identical to the one used by the machine to interconnect with its
conventional pushbutton panel.
ATTENTION!:
THE CONNECTION MUST BE MADE IN SUCH WAY THAT WHEN THE
MAIN SWITCH IS TURNED OFF, THE RECEIVER IS ALSO TURNED OFF.
ATTENTION!:
AS A SAFETY MEASURE IT IS ESSENTIAL TO ENSURE AN EARTH
CONNECTION VIA THE CORRESPONDING PIN OF THE CONNECTOR.
The standard receiver can be powered by a voltage in the range of 48 to 240 Vac.
For more details on the wiring of the relays associated with the controls, please refer to the relay output
sheet supplied with the receiver.
1
Applicable only in Spain
