2
ITI® Aritech APW 450 PIR Motion Sensor
Product Summary
Preliminary 4/18/00
Figure 2. This graph shows the top view of the lens cov-
erage area, for the indoor motion sensor’s
lens.
Figure 3. Side view (Motion Sensor) at a mounting
height of 7.5 feet.
Mounting the Motion Sensor
This sensor must be incline-mounted on a wall surface or
incline mounted in a corner at a mounting height of 7.5 feet.
Figure 4. Wall mount options
To mount the sensor:
1.
Remove the mounting plate by depressing the button
on the top of the sensor body. With the opposite hand
pull the mounting plate away from the body of the sen-
sor.
2.
Punch out two of the bottom four mounting holes. See
Figure 4 for wall mount options. Use the lower-side
holes for corner mounting, or the lower-middle holes
for surface mounting.
3.
If you desire wall-tamper functionality, remove the
wall-tamper knockout.
Figure 5. PIR Mounting plate knockouts
Note
The wall-tamper switch cannot be used when the sen-
sor is corner mounted.
4.
Mark the location of the required holes on the mount-
ing surface.
5.
Use wall anchors and screws to secure into place.
Attach the sensor to the mounting plate.
8362G11A.DS4
0 ft
20 ft
20 ft
0 ft
10 ft
20 ft
0 m
11 m
TOP VIEW
6 m
3 m
0 m
3 m
6 m
35 ft
7.5 ft
0 m
4 ft
0 ft
35 ft
11 ft
2.4 m
1.2 m
0 m
0 ft
DO NOT FLUSH MOUNT
INCLINED MOUNT
CORNER MOUNT
DO NOT MOUNT
USING SWIVEL MOUNT
USE WITH
STANDARD LENS
U S E W I T H
A N I M A L A L L E Y L E N S
8855G01A.DSF
WALL
TAMPER
KNOCKOUT
USE THESE
MOUNTING
HOLES
DO NOT
USE THESE
MOUNTING
HOLES
