Page 4
System Sensor Smoke Sen-
Specifications
Compatibility:
Dimensions:
Operating Temperature Range:
32° (0°C) to 100°F
(38°C).
Power Source:
Two 3-volt lithium batteries of the
same type. UL-approved types: Sanyo CR123A, Pana-
sonic CR123A, Duracell DL123A.
Notices
Agency Listings: UL 268—Residential Installations
NFPA 72, Chapter 2, Section 2-2.1.1.1 states as follows: “Smoke sensors shall be
installed outside of each separate sleeping area in the immediate vicinity of the bed-
rooms and on each additional story of the family living unit, including basements and
excluding crawl spaces and unfinished attics. In new construction, a smoke sensor also
shall be installed in each sleeping room.”
The above NFPA standard is a minimum requirement for smoke sensor installation. For
better protection, we also require the installation of a smoke sensor inside every bed-
room in existing construction.
This device complies with part 15 of the FCC rules. Operation is subject to the following
two conditions:
1) This device may not cause harmful interference.
2) This device must accept any interference received, including interference that may
cause undesired operation.
Changes or modifications not expressly approved by Interactive Technologies, Inc. can
void the user’s authority to operate the equipment.
FCC Registratio No.: B4Z764A-SMOKE
ITI is a registered trademark of Interactive Technologies, Inc. System Sensor is a trade-
mark of System Sensor.
6 5 1 / 7 7 7 - 2 6 9 0
6 5 1 / 7 7 9 - 4 8 9 0